Panelled Doors

 
4 Panel
6 Panel
Half Glazed
10 Pane
15 Pane
2'0
Y
Y
N
N
N
2'3"
Y
Y
Y
Y
N
2'6"
Y
Y
Y
Y
Y
2'9"
Y
Y
Y
N
Y
 
Fire (FD30)
Y
Y
N
N
N
Our panelled oak interior doors have a stable softwood core with generous 10mm solid oak wear strips at each side and oak veneered panels surrounded by integral solid oak mouldings. Some natural colour variation should be expected from oak wood doors, and please note that there is a slight difference between the panel construction of standard doors and fire doors. 
 
Each design is available in a choice of widths as shown in the adjacent table. They are 40mm thick (except fire doors, which are 44mm) and 1981mm high. 
 
Panelled oak doors can be adjusted as follows:
 
Laterally: up to 5mm on each side
Vertically: up to 25mm from the top and 50mm from the bottom

Installation

Hang on 3 good quality butt hinges suitable for their weight (approx 25kg). Please note that existing slamming strips / door stops that have been set for 35mm doors will need to be adjusted to accommodate the additional thickness of our doors. 
 
If you are using our panelled oak fire doors, please note that closers and smoke seals may be required to be fitted with these to comply with building regulations. Oak door liners with integral smoke seals are available to match these doors in this case.

Finishing

If you do not order your panelled oak doors with one of our door finishes they will be supplied unsealed and will need to be lightly hand sanded after fitting with 120 grit paper and sealed with a suitable interior finish to protect from marks and general wear and tear. If you choose one of our workshop finishes, no further finishing will be required. Please bear in mind that in this case additional care will be necessary at fitting stage to avoid damaging the finish (although we can supply touch up pots in the event of any accidents).

Storage

Our panelled oak doors should always be stored flat, with a solid support that will not damage their surface (i.e. a sheet of chipboard on a concrete sub-floor) between the bottom door and the floor. Never store our internal oak doors outside, nor in an environment in which wet works have not fully dried (as defined in Section 1 of Installation Guide – Floors).

 

 
Newsletter Sign Up
Keep up to date with all the new products and trends at Broadleaf